Segway-Ninebot eKickScooter E2 Pro error codes · Segway-Ninebot E2 Pro

Error 10 on Segway-Ninebot E2 Pro

What it means + how to fix it From the manual

Quick answer

Error 10 on the Segway-Ninebot eKickScooter E2 Pro means “Dashboard communication is abnormal.” Most likely cause: the display, controller and battery have stopped talking to each other properly. Try this first: switch off and restart.

Try this first

Free, and each takes under 5 minutes.

Switch off and restart
Write down the code and when it happens

In plain English

The parts of the scooter share data over a cable through the stem and deck. This code means that link was lost. A restart sometimes clears it. If it stays, support can check the connections.

Step-by-step checklist

Work from the top. Steps go from free and easy to shop jobs. Switch the scooter off before touching any connector. Tick each step as you go. Your progress is saved on this device.

1Switch off and restartFree Turn the scooter off, wait 30 seconds, then turn it back on. If the code clears, note what you were doing when it appeared, in case it comes back.
2Write down the code and when it happensFree Take a photo of the display and note when the code appears: at switch-on, when you set off, on hills, in rain or while charging. Support will ask for this.
3Contact support or a service centerShop job If the code stays after these checks, stop riding and contact the brand's customer support or an authorized service center. Don't open the deck, battery, controller or motor: most scooter batteries and controllers aren't user-serviceable.

Still not fixed?

Pages to try next:

All Segway-Ninebot eKickScooter E2 Pro codes

When it's time for a shop: if you've worked through every step and the problem is still there, contact the brand's support or an authorized service center. Bring your notes on when it happens, plus the code.

Words on this page: Controller