E Ride Pro error code list · E Ride Pro SS 3.0 & Mini

Error 00600 on E Ride Pro SS 3.0 & Mini

What it means + how to fix it From the manual

Quick answer

Error 00600 on the E Ride Pro SS 3.0 / Mini means “Tilting Error.” Most likely cause: the bike fell or leaned over, or the tip-over sensor has a fault. Try this first: stand the bike upright and restart.

Try this first

Free, and each takes under 5 minutes.

Stand the bike upright and restart
Switch off and restart

In plain English

The tip-over sensor cuts power when the bike falls over, so the motor can't spin while it's on the ground. Standing it up and restarting usually clears it. If it stays on while upright, the sensor needs checking.

Step-by-step checklist

Work from the top. Steps go from free and easy to shop jobs. Switch the bike off before touching any connector. Tick each step as you go. Your progress is saved on this device.

1Stand the bike upright and restartFree Tip-over and tilt sensors cut power after a fall or when the bike leans too far. Stand it upright, switch off, wait a few seconds, then switch back on.
2Switch off and restartFree Turn the bike off with its key or power switch, wait 30 seconds, then turn it back on. If the code clears, note what you were doing when it appeared, in case it comes back.
3Contact an authorized dealerShop job If the code stays after these checks, stop riding and contact an authorized dealer for your brand. The battery, motor, controller and high-voltage wiring are for trained technicians only. Don't open them or unplug high-voltage connectors.

Still not fixed?

Pages to try next:

All E Ride Pro SS 3.0 / Mini codes

When it's time for a shop: if you've worked through every step and the problem is still there, contact an authorized dealer for your brand. Bring your notes on when it happens, plus the code.

Words on this page: Controller