Yozma IN 10 status code list · Yozma IN 10 & IN 10 Pro

E13 Error on Yozma IN 10 & IN 10 Pro

What it means + how to fix it From the manual

Quick answer

E13 on the Yozma IN 10 / IN 10 Pro means “Front Light Error.” Most likely cause: a fault in the headlight or its wiring. Try this first: switch the light off and on.

Try this first

Free, and each takes under 5 minutes.

Switch the light off and on
Switch off and restart

In plain English

The system found a problem with the front light circuit. Turn the light off and on, and have the light checked if the code stays.

Step-by-step checklist

Work from the top. Steps go from free and easy to shop jobs. Switch the bike off before touching any connector. Tick each step as you go. Your progress is saved on this device.

1Switch the light off and onFree Turn the headlight off and back on from the display, then restart the bike. Check the light isn't cracked or full of water.
2Switch off and restartFree Turn the bike off with its key or power switch, wait 30 seconds, then turn it back on. If the code clears, note what you were doing when it appeared, in case it comes back.
3Contact an authorized dealerShop job If the code stays after these checks, stop riding and contact an authorized dealer for your brand. The battery, motor, controller and high-voltage wiring are for trained technicians only. Don't open them or unplug high-voltage connectors.

Still not fixed?

Pages to try next:

All Yozma IN 10 / IN 10 Pro codes

When it's time for a shop: if you've worked through every step and the problem is still there, contact an authorized dealer for your brand. Bring your notes on when it happens, plus the code.

Words on this page: Controller