Yozma IN 10 status code list · Yozma IN 10 & IN 10 Pro

E08 Error on Yozma IN 10 & IN 10 Pro

What it means + how to fix it From the manual

Quick answer

E08 on the Yozma IN 10 / IN 10 Pro means “Throttle Error.” Most likely cause: a sticking throttle, a loose throttle plug or a faulty throttle. Try this first: check the throttle snaps back.

Try this first

Free, and each takes under 5 minutes.

Check the throttle snaps back
Switch off and restart

In plain English

The controller is getting a wrong signal from the throttle. A throttle that sticks or doesn't return can make the bike move unexpectedly, so don't ride until it's fixed.

Step-by-step checklist

Work from the top. Steps go from free and easy to shop jobs. Switch the bike off before touching any connector. Tick each step as you go. Your progress is saved on this device.

1Check the throttle snaps backFree With the bike switched off, twist the throttle and let go. It should snap fully back on its own. Clear mud or sand from around the grip, and make sure nothing is pressing on it.
2Switch off and restartFree Turn the bike off with its key or power switch, wait 30 seconds, then turn it back on. If the code clears, note what you were doing when it appeared, in case it comes back.
3Contact an authorized dealerShop job If the code stays after these checks, stop riding and contact an authorized dealer for your brand. The battery, motor, controller and high-voltage wiring are for trained technicians only. Don't open them or unplug high-voltage connectors.

Still not fixed?

Pages to try next:

All Yozma IN 10 / IN 10 Pro codes

When it's time for a shop: if you've worked through every step and the problem is still there, contact an authorized dealer for your brand. Bring your notes on when it happens, plus the code.

Words on this page: Controller Throttle