SHIMANO STEPS error and warning codes · SHIMANO STEPS

E259 Error on SHIMANO STEPS

What it means + how to fix it From the brand

Quick answer

E259 on the SHIMANO STEPS (EP8, EP6, E8000, E7000, E6100, E5000 and others) means “Electrical abnormality in battery detected..” Most likely cause: a fault inside the battery or its management system (BMS). Try this first: turn it off and on again.

Try this first

Free, and each takes under 5 minutes.

Turn it off and on again
Reseat the battery

Code meanings vary by brand. The same number can mean different things on different displays and controllers. Check your bike's manual to confirm.

About the SHIMANO STEPS (EP8, EP6, E8000, E7000, E6100, E5000 and others)

From Shimano's official Error & Warning Code page on si.shimano.com, checked October 23, 2026. It is one list for all SHIMANO STEPS systems, not split by model. source
Shimano's EP801 / EP600 manual and its special battery and parts manual send riders to this page for error codes. source
The SC-E6100 cycle computer manual also points to this list. An "E" code shown on the entire screen means the product may have malfunctioned. A "W" code means it may have a temporary problem. source
Shimano also lists 5-digit codes (like E01010 or W10000), but says they are only used in E-TUBE PROJECT Professional, the dealer software. They don't show on the bike, so they are not listed here. source
Codes can differ between E-TUBE PROJECT Professional and your cycle computer or app. Older displays may show only some of these codes. source

In plain English

The battery has its own management system that watches its cells, temperature and charging. This code means it found a problem inside the battery. Some clear after a restart, but a code that stays needs a shop or the brand. Never open the battery.

Step-by-step checklist

Work from the top. Steps go from free and easy to shop jobs. Switch the bike off before touching any connector. Tick each step as you go. Your progress is saved on this device.

1Turn it off and on againFree Switch the display off, wait 30 seconds, then switch it back on. If the code clears, note what you were doing when it appeared, in case it comes back.
2Reseat the batteryFree Switch off and slide or lift the battery out of its mount. Wipe any dirt off the metal contacts on the battery and the mount, then put it back until it clicks and locks.
3Have the battery testedShop job A shop can test the battery and its protection circuit and tell you if it needs replacing. Never open the battery pack yourself.

Parts you might need

As an Amazon Associate I earn from qualifying purchases. These links go straight to Amazon.

Only buy a part if the free steps didn't fix it. Always match the voltage and connector type to your bike.

Electrical contact cleaner spray
Cleans dirt and corrosion from connector pins and battery contacts.
View on Amazon

Still not fixed?

Pages to try next:

When it's time for a shop: if you've worked through every step and the problem is still there, take the bike to an e-bike shop. Bring your notes on when it happens, plus the code.