Error 34 on Rad Power Bikes Color Display

In plain English

This code points to the power button or keypad. Bafang's E162 manual says holding the power button while the display turns on triggers it, so release the button first. A stuck or wet button pad is the next most likely cause.

Work from the top. Steps go from free and easy to shop jobs. Switch the bike off before touching any connector. Tick each step as you go. Your progress is saved on this device.

1. 1Release the power buttonFree Make sure you're not still holding the power button as the display turns on. Release it and see if the code clears.
2. 2Turn it off and on againFree Switch the display off, wait 30 seconds, then switch it back on. If the code clears, note what you were doing when it appeared, in case it comes back.
3. 3Check for a stuck buttonEasy Press each button on the handlebar pad a few times. A button stuck down by dirt or water can send commands non-stop. Clean around it and check the pad's cable and plug.
4. 4Have the controller testedShop job If the wiring checks out, the controller may be faulty. A shop can test it and replace it if needed.

Parts you might need

As an Amazon Associate I earn from qualifying purchases. These links go straight to Amazon.

Only buy a part if the free steps didn't fix it. Always match the voltage and connector type to your bike.

• Display button pad (remote)

  Replaces a sticky or broken handlebar button pad. Must match your display.

  Match your bike's model first. Ask a shop if unsure.