GOTRAX Fitz16 error code list · GOTRAX Fitz16

E3 Error on GOTRAX Fitz16

What it means + how to fix it From the brand

Quick answer

E3 on the GOTRAX Fitz16 electric dirt bike means “Brake failure.” Most likely cause: a brake lever is held, sticking, or its sensor has a fault. Try this first: check the brake levers spring back.

Try this first

Free, and each takes under 5 minutes.

Check the brake levers spring back
Switch off and restart

In plain English

The brake levers have sensors that cut motor power when you brake. This code means the system is getting a brake signal it doesn't expect.

Step-by-step checklist

Work from the top. Steps go from free and easy to shop jobs. Switch the bike off before touching any connector. Tick each step as you go. Your progress is saved on this device.

1Check the brake levers spring backFree Squeeze and release each brake lever. Both should snap all the way back. A lever that stays slightly pulled keeps the motor switched off.
2Switch off and restartFree Turn the bike off with its key or power switch, wait 30 seconds, then turn it back on. If the code clears, note what you were doing when it appeared, in case it comes back.
3Contact an authorized dealerShop job If the code stays after these checks, stop riding and contact an authorized dealer for your brand. The battery, motor, controller and high-voltage wiring are for trained technicians only. Don't open them or unplug high-voltage connectors.

Still not fixed?

Pages to try next:

All GOTRAX Fitz16 electric dirt bike codes

When it's time for a shop: if you've worked through every step and the problem is still there, contact an authorized dealer for your brand. Bring your notes on when it happens, plus the code.

Words on this page: Controller