Bosch eBike system error codes (Purion, Intuvia, Kiox, Nyon, before the smart system) · Bosch Purion, Intuvia, Kiox, Nyon

Error 592 on Bosch Purion, Intuvia, Kiox, Nyon

What it means + how to fix it From the manual

Quick answer

Error 592 on the Bosch Purion, Intuvia, Kiox and Nyon (before the smart system) means “Incompatible component.” Most likely cause: a battery, charger or other part that isn't designed for this system. Try this first: turn it off and on again.

Try this first

Free, and each takes under 5 minutes.

Turn it off and on again

Code meanings vary by brand. The same number can mean different things on different displays and controllers. Check your bike's manual to confirm.

About the Bosch Purion, Intuvia, Kiox and Nyon (before the smart system)

Bosch prints this same table in the Purion (BUI215) MY2023 US manual (pages English 12 to 14). source
The same table is in the Intuvia (BUI255) MY2021 US manual (pages English 15 to 17). source
The same table is in the Kiox Online Version (BUI330) MY2020 US/CA manual (pages English 35 to 38). source
The same table is in the Nyon Online Version (BUI350) MY2021 US manual (pages English 66 to 69). Bosch notes code 430 does not apply to the BUI350. source
These displays belong to Bosch's older eBike system, not the smart system. The Bosch smart system (for example the Purion 200 and Kiox 400C) uses six-character error numbers instead. source
Bosch also lists "7xx" for faults in third-party parts, and "Display is blank" for an internal fault of the on-board computer. They are not single codes, so they are not in this list. source

In plain English

The system found a part it isn't made to work with, such as a different battery, charger or display. Only use parts your bike maker or the system brand lists for your bike. A dealer can confirm which parts fit.

Step-by-step checklist

Work from the top. Steps go from free and easy to shop jobs. Switch the bike off before touching any connector. Tick each step as you go. Your progress is saved on this device.

1Turn it off and on againFree Switch the display off, wait 30 seconds, then switch it back on. If the code clears, note what you were doing when it appeared, in case it comes back.
2Did you just change a part?Moderate Displays, controllers and batteries must be a compatible match (the same communication protocol), not just share a plug. If the problem started right after you replaced something, put the old part back or check compatibility with the seller.
3Ask a dealer which parts fitShop job A dealer for your bike's system can check the part numbers and fit a compatible part.

Still not fixed?

Pages to try next:

All Bosch Purion, Intuvia, Kiox and Nyon (before the smart system) codes

When it's time for a shop: if you've worked through every step and the problem is still there, take the bike to an e-bike shop. Bring your notes on when it happens, plus the code.

Words on this page: Controller