Bafang DP E170.CAN / E180.CAN / E181.CAN code list · Bafang DP E170 / E180 / E181 Display

Error 36 on Bafang DP E170 / E180 / E181 Display

What it means + how to fix it From the manual

Quick answer

Error 36 on the Bafang E170 / E180 / E181 means “Detection circuit on the keyboard (keypad) has an error.” Most likely cause: holding the power button while switching on, or a stuck button. Try this first: restart the system first.

The E170 manual says "keyboard" and the E180 / E181 manual says "keypad".

Try this first

Free, and each takes under 5 minutes.

Restart the system first
Release the power button

In plain English

This code points to the power button or keypad. Bafang's E162 manual says holding the power button while the display turns on triggers it, so release the button first. A stuck or wet button pad is the next most likely cause.

Step-by-step checklist

Work from the top. Steps go from free and easy to shop jobs. Switch the bike off before touching any connector. Tick each step as you go. Your progress is saved on this device.

1Restart the system firstFree Bafang's manual says to restart first whenever an error code appears: switch the system off, wait a few seconds, then switch it back on. If the code doesn't go away, carry on with the steps below.
2Release the power buttonFree Make sure you're not still holding the power button as the display turns on. Release it and see if the code clears.
3Check for a stuck buttonEasy Press each button on the handlebar pad a few times. A button stuck down by dirt or water can send commands non-stop. Clean around it and check the pad's cable and plug.
4Have the controller testedShop job If the wiring checks out, the controller may be faulty. A shop can test it and replace it if needed.

Parts you might need

As an Amazon Associate I earn from qualifying purchases. These links go straight to Amazon.

Only buy a part if the free steps didn't fix it. Always match the voltage and connector type to your bike.

Display button pad (remote)
Replaces a sticky or broken handlebar button pad. Must match your display.
Link coming soon

Still not fixed?

Pages to try next:

When it's time for a shop: if you've worked through every step and the problem is still there, take the bike to an e-bike shop. Bring your notes on when it happens, plus the code.

Words on this page: Controller